Belt-loop-foot-for-janome-1200d-and-elna-845-overlockers

Belt Loop Foot Part number 200 808 002.

BELT LOOP FOOT (L)Easily duplicate the belt loops found in the garment industry using a Wide or Triple Cover Hem. This foot automatically folds under bias strip edges for belt loops, decorative accents, button loops, narrow straps, etc. The possibilities are limited only by your imagination.CREATING BELT LOOP DECORATIVE ACCENTS1. Select sewing program:(10) Triple Cover Hem or Cover Hem Wide 2. Thread and set up machine as indicated on the machine or in your instruction manual. 3. Cut a strip of bias tape 2.7 cm (1 1/8”) wide. Cut one end at a 45° angle. Insert cut angle (fabric right side facing up) into belt loop foot. See Figure 37. 4. Pull bias tape under foot and extend it behind foot. See Figure 38.5. Attach belt loop foot.6. Lower needles into bias tape. Lower presser foot. Be sure both edges of bias are turned under before stitching. Sew first two stitches by hand turning the handwheel. Sew belt loop strip at a medium speed. See Figure 39.*VARIATION 1: Sew belt loops directly onto fabric for a decora-tive effect. Place a medium to heavy weight fabric underneath foot. Use a stabilizer on fabric to prevent puckering. See Figure 40.VARIATION 2: Sew belt loop strip. Use a sewing machine with clear monofilament needle thread to attach belt loop strip to fabric surface for decorative effect.Belt Loop Foot (L): 200-808-00237383940*NOTE: For best results, pull fabric slightly to the left while sewing.

Easily duplicate the belt loops found in the garment industry using a Wide or Triple Cover Hem. This foot automatically folds under bias strip edges for belt loops, decorative accents, button loops, narrow straps, etc.